Sliding knots are an easy way to make your jewelry adjustable. Pull one end past the other so that they overlap by about four inches (10 cm). Some people think that super glue can erode the elastic over time.
Now, Wrap The Cord Around The Loop Twice, And Then Tighten To Secure.
The square knot is equal on both sides. If you desire an adjustable bracelet, make a sliding knot. Pull a long cord into a u or horseshoe shape.
Cut Two Satin Cords Into Bracelet Lengths Needed.
Knot the end of each thread. Place your bracelet in the position with the face of the bracelet facing down and the knotted side up towards you. Bend it towards the opposite direction and follow the steps as listed above.
It Holds Tight And Is Easily Hidden Between Beads Or Inside Seed Beads.
Pull the bracelet tight around the braid by holding it close to the looped edge. Place the bracelet flat on a surface. Bend the tip and bring it back along the outside.
Some Good Choices Of Fiber Cord Are Hemp, Waxed Cotton, Or Chinese Knotting Cord.
Lay two satin cords down, side by side. Open the bracelet up as much as you need to move your hand in. So bring lay the left hand cord across the bracelet, leaving a loop.
